*This epoxy putty will plug holes and make permanent repairs in moist-surface or under water applications
*Will even repair leaking fuel tanks
*Simply pull off the amount of Waterweld necessary for the job, knead it with your fingers until the two colors are thoroughly mixed, then push the product into the hole
*Will fully cure in 20-30 minutes
*Can be drilled, sanded, filed, tapped, machined, and painted
*Nontoxic and approved by the National Sanitation Foundation for use with potable water
*300ş F maximum intermittent temperature
*250ş F maximum continuous temperature
*1000 psi lap shear tensile strength
*12000 psi compressive strength
*Less than 1% shrinkage
*Light Grey
*Made in USA
*Carded